![]() The steps necessary to set up your individual command station areįound on the wiki page of the respective command station.įor quick navigating on large pages use the Table of Contents in the top right corner of each pageįor quick navigating between the last visited pages use the Trace Bar found at the end of each pageįor a print-out use the link Printable Version from the toolbox at the lower end of the navigation bar on the left: The contents remains the same, though.Īn explanation of settings of all command stations supported is beyond the scope of this general introduction. Operating system and personal settings, eventually look slightly different from the figures presented here. Thus, dialogues and settings pages will, depending on the it should apply equally to all operating systems and command stations. This tutorial is kept as general as possible, i.e. By this it may offer valuable suggestions even to the advanced user. Of a track plan to a fully automatic control of the layout. It will guide the user from software downloading and installation through adding of locomotives and the creation This page aims to facilitate the first steps of beginners especially. This page as downloadable PDF: Rocrail Step-by-Step (Version of March 23, 2011) 1 von 40 12:13īefore You Start | Quick Guide | Step-by-Step Tutorial The newest Rocrail revision is the topmost file in the list (red arrow in the figure below). Tip: Windows user may also download a Nightly Build from. ![]() Look for the appropriate operating system in the column Description, then choose the download link left below of File. Tips Using Wiki Pages For quick navigating on large pages use the Table of Contents in the top right corner of each page For quick navigating between the last visited pages use the Trace Bar found at the end of each page For a print-out use the link Printable Version from the toolbox at the lower end of the navigation bar on the left: 1.0 Basics This section describes the very basic steps: Downloading, program installation, starting Rocrail for the first time and learning the concept from the demo track-plan. The steps necessary to set up your individual command station are found on the wiki page of the respective command station. An explanation of settings of all command stations supported is beyond the scope of this general introduction. Thus, dialogues and settings pages will, depending on the operating system and personal settings, eventually look slightly different from the figures presented here. ![]() ![]() It will guide the user from software downloading and installation through adding of locomotives and the creation of a track plan to a fully automatic control of the layout. JMRI is great for decoder programming and setting up signal logic, but some of the other stuff they keep cramming in I have to question.Step-by-Step Tutorial Content → Getting Started Before You Start | Quick Guide | Step-by-Step Tutorial The Gateway to Rocrail This page as downloadable PDF: Rocrail Step-by-Step (Version of March 23, 2011) Preface This page aims to facilitate the first steps of beginners especially. ![]() Code should be indented for readability, not because it uses that to denote procedures and other types of code blocks. Who ever though that was an great idea? I have no idea why anyone would use it. And he's a lawyer - I'm the computer guy.ĪNd I'm sorry, any programming or scripting language that relies on proper indenting is a complete non-starter (jython). Between visits, he downloaded a trial of RR&Co Silver and had the whole thing working the next time I came over, 4 sets of trolley cars following each other at least one block apart and it ran for hours with no faults. Start setting up the automatic script and section 5 would go occupied along wih section 11 which is where the trolley really was. I could run a trolley manually and monitor the detections and they were all fine. Besides a couple of false starts since it seems nearly impossible to undo a mistake in setting up the track (removed the bad piece, put in a new one, but in the end it acted like the removed part was still there - dang XML for a database.), I was also getting spurious detections constantly. A friend of mine wanted to set up multiple trolleys to run through his oen town, so I tried doing it with JMRI. For automation, I'd give the nod to RR&Co. ![]()
0 Comments
Leave a Reply. |